Thanks for downloading ROBOTXControl.
ROBOTXControl is an open source program.
If you have paid for this program, please contact the developers on
http://sourceforge.net/projects/robotxcontrol/
Content:
1. Installation
2. First use
3. Use
4. Contact
5. Disclaimer
1. Installation
Install the .jar file on your phone. For this, you can use software from
your phone's manufacturer.
Now you're phone is ready to control your ROBO-TX.
After that, you have to open ROBOPro. You have to make 9
programs for driving motors, lights, buzzer,... (Just make functions you want)
Keys to program names bindings (key - program name):
1 - function1.rpp
2 - forward.rpp
3 - function2.rpp
4 - left.rpp
6 - right.rpp
7 - function3.rpp
8 - backward.rpp
9 - function4.rpp
And one special program stop.rpp that loading and starting when you
release any key.
Pressing one of those keys will result in loading and starting the
related program.
!!! These name's MUST be correct, otherwise the ROBO-TX will show errors !!!
Example programs for the ROBO-TX you can get from
http://robotxcontrol.svn.sourceforge.net/viewvc/robotxcontrol/branches/0.0.x/robotxcontrol/robopro/.
After downloading these programs to your ROBO-TX's flash memory, your
ROBO-TX is also ready. !!! Make sure that Bluetooth on your robot is
turned on and the ROBO-TX is visible to other Bluetooth devices and
linking between the ROBO-TX and other devices is enabled.
If you don't know how this works, please refer to the ROBO-TX manual.
All BT-settings are placed on the ROBO-TX under:
Menu->Settings->Bluetooth
2. First use
When you're going to use this program for the first time,
follow the steps below. If you already used another version of this
program, go to Chapter 3.
First you have to create a link between your phone and ROBO-TX. To do this:
a. Go to the BT menu of your phone
b. Select linked devices (or something else like that)
c. Select "Add new device"
d. Select now the ROBO-TX controller (or the name from your TX if you renamed it)
e. The password is 1234
A link will be created.
3. Use
Open the program. You'll have to enter the BT address of your
ROBO TX controller. (You can find this on your TX by going to
Menu->Information->Bluetooth address). Enter this address to the program.
Now you can press a key (1-9) to start the related program.
Example:
key nr. "2" makes the robot drive forward
key nr. "4" makes the robot turn left
...
When no key is pressed, the robot will run the "stop" program, related to key
nr.5.
If you want to exit, select disconnect, then options, Exit.
The last entered BT address will be remembered.
4. Contact
Project website:
http://sourceforge.net/projects/robotxcontrol/
Contact (E-mail):
ft-ninja@users.sourceforge.net (primary)
gamesbond007@users.sourceforge.net
A
forum is available for questions.
If you have questions, please take also a look in the ROBO-TX manual,
for problems with your phone in your phone's manual.
5. Disclaimer
No one of these programs is made to destruct something. The developers
are NOT responsible for any defects and so on. By using the program you
automatically accept with this manual and disclaimer.
Peace!
