Hey,
ich habe vor, die Firmware von meinem Robo Tx Controller (Aktuell: V. 1.30) in die Version V. 1.18 zu ändern.
Ich habe leider keine Ahnung wie das geht, da bei meinem Robo pro unter "Test" -> "Info" nichts mit Firmware aufgelistet ist...
So sieht das bei mir aus...
Hat jemand ne Ahnung wie das geht und wo ich überhaupt die Version V. 1.18 finden kann?
Danke im Vorraus
Robo TX Firmware manuell ändern
Forumsregeln
Bitte beachte die Forumsregeln!
Bitte beachte die Forumsregeln!
Re: Robo TX Firmware manuell ändern
Hallo,
wenn Du eine alte Version von Robo Pro besitzt, hilft vielleicht der Tip von http://www.ftcommunity.de/ftComputingFi ... dllstx.htm weiter (unter dem Bild des TX Controllers)
Gruß Ulrich Müller
wenn Du eine alte Version von Robo Pro besitzt, hilft vielleicht der Tip von http://www.ftcommunity.de/ftComputingFi ... dllstx.htm weiter (unter dem Bild des TX Controllers)
Gruß Ulrich Müller
Re: Robo TX Firmware manuell ändern
In addition to the webpage from Mueller, there is also FtMscLibEx.DLL available from fischertechnik.
This is an extended version of the FtMscLib, compiled with MS-Visual Studio 2012/2010.
This lib also support FtMscLibEx event driven programming and the use of events inside C++ classes.
This is an extended version of the FtMscLib, compiled with MS-Visual Studio 2012/2010.
This lib also support FtMscLibEx event driven programming and the use of events inside C++ classes.