Seite 1 von 1
TX I2C Belastbarkeit 5Volt Port
Verfasst: 22 Jun 2012, 14:35
von thomasdr
Hallo,
ich möchte per SAA 1064 LED´s per I2C steuern. Weiss jemand wie wie viel Strom ich dem 5Volt Port des TX Controllers entnehmen darf ?
Danke
Re: TX I2C Belastbarkeit 5Volt Port
Verfasst: 22 Jun 2012, 23:57
von vleeuwen
It is very commen to give an I2C device its proper power supply.
Innenleben TX Controller
Verfasst: 23 Jun 2012, 12:19
von thomasdr
Bei dieser Gelegenheit habe ich einen Blog zum Innenleben des TX gefunden.
Zumindest muss den eigenen TX nicht aufschrauben um etwas über die Hardware zu erfahren.
http://www.stefanbrunner.com/fischertechnik-robo-tx
Re: TX I2C Belastbarkeit 5Volt Port
Verfasst: 23 Jun 2012, 17:05
von vleeuwen
That technical description looks like superficial.
The TX-C API description is more clear about the difference between Motor and Output function.
For example, the brake funcionality is missing.
Ad2 and Rei Velo did already publish a lot more details information about the TX-C on the forum.
Maybe I am wrong but form the fischertechnik documentation I understood that the fast counters knows a sample rate of 1 Khz (1 ms interval). See also some discussion that took place on this forum in 2011.