I'm trying to use a fischertechnik robo tx controller but when I make click in Run TransferArea in ROBO TX Controller Test an error is displayed: TransferArea was not started. The ftMscLib.dll is in the same directory than RoboTxTest.exe
Log file show this
Code: Alles auswählen
11:03:43:468, OpenComDevice(), comStr= COM10
11:03:43:506, ftxOpenComDevice(), ftHandle= 732
11:03:43:506, Starting thread [ReadComThread]...
11:03:43:506, Thread [ReadComThread] started..., hComRead= 736, IdComReadThread= 2852
11:03:43:506, Open Fish.X1 connection...
11:03:43:511, [SetFishX1InfoData] shmId= 0
11:03:43:511, Hostname : ROBO TX-323
11:03:43:511, BtAddress : 00:13:7B:53:03:5F
11:03:43:511, Hardware Release : C
11:03:43:511, Firmware Version : V 1.04
11:03:43:511, DLL Version : V 0
11:03:43:511, SharedMemoryStart : 0x20000204
11:03:43:511, AppAreaStart : 0x30700000
11:03:43:511, AppAreaSize : 0x000F0000
11:03:43:513, Initialization output and config area...
11:03:43:513, Info Master/Slave alive: M 0 0 0 0 0 0 0 0
11:03:43:513, InitTransferValues, Initialization of TransferArea (output)...
11:03:43:614, SendRemoteCmd, XM_START: send remote command: 'get_ser_num'
11:03:43:626, SendRemoteCmd, XM_GET_PROMPT: ROBO TX prompt received...
11:03:43:626, serial_number= [0001711782]
11:03:45:267, Starting Fish.X1 transfer...
11:03:45:267, SetFishX1TransferStatus, set status = 2
11:03:51:767, Timeout by starting TransferArea ..., ThreadWriteFlag= 1
11:03:51:767, StartFishX1Transfer, IFStatus.status = 2
11:03:51:767, Stopping Fish.X1 transfer...
11:03:51:767, SetFishX1TransferStatus, set status = 0
11:03:51:767, Fish.X1 transfer stopped ...
11:03:51:895, INFO: SetFtRequest, TransferArea stopped while Timeout is occurred...ftTimeOut= 6600
11:03:51:895, SetFishX1TransferStatus, set status = 0https://www.dropbox.com/s/ued2i72rjpsqsyw/error.png
Somebody can help me?
Thank you