Command Filters not up to date
Verfasst: 16 Apr 2020, 14:08
I was busy with creating an simulation subroutine for the FT-motor and the Ft encoder motor.
I discover that the list in the two RoboPro filter elements are not covering all the commands.
I looks like that RoboPro is a little bit out date concerning command handeling.
I hope that these command will add to the list.
Missing are:
I tested this.
This will give a problem when the used language in RoboPro has been change
I discover that the list in the two RoboPro filter elements are not covering all the commands.
I looks like that RoboPro is a little bit out date concerning command handeling.
I hope that these command will add to the list.
Missing are:
- Synchronous
- Reset
- Distance
I tested this.
This will give a problem when the used language in RoboPro has been change