Command Filters not up to date

Hier habt Ihr die Möglichkeit direkt mit dem fischertechnik Team in Kontakt zu treten
Here you have the Possibility to get in direct contact with the fischertechnik-Team

Moderator: fischertechnik Mitarbeiter

Bitte beachte die Forumsregeln!

In dieser Unterkategorie können nur fischertechnik-Mitarbeiter und Moderatoren antworten!
Beiträge: 1280
Registriert: 31 Okt 2010, 22:23
Wohnort: Enschede (NL)

Command Filters not up to date

Beitrag von vleeuwen » 16 Apr 2020, 14:08

I was busy with creating an simulation subroutine for the FT-motor and the Ft encoder motor.
I discover that the list in the two RoboPro filter elements are not covering all the commands.
I looks like that RoboPro is a little bit out date concerning command handeling.
I hope that these command will add to the list.
Missing are:
  • Synchronous
  • Reset
  • Distance
Command filter
Command filter
CommandFilter1.JPG (40.5 KiB) 1090 mal betrachtet
Command branch filter
Command branch filter
CommandFilter2.JPG (50.49 KiB) 1090 mal betrachtet
2020-04-19 Workaround for this problem, add the commands manual to the filter.
I tested this.
This will give a problem when the used language in RoboPro has been change
MotorSimulation06.JPG (26.31 KiB) 1027 mal betrachtet