fischertechnik community forum

When using the IR remote with the Robotics TXT, and even with a new 9 V battery, the signal from the infra-red remote control isn’t continuous.



A program as basic as the previous one fails to run the motor continuously.

Pushing the joystick up to the top or down to the bottom and maintaining it on that position results with the motor being stopped.

My simple infrared program to control a driving car doesnt make problems. Here is a Link to my Super infrared test: https://www.dropbox.com/s/8m7t6g7v6i96g ... l.rpp?dl=0 In the last version i have removed the extra only positive and only negative variables, but i think these are handled by the software.

Raphael

Dear Rei Vilo,

meanwhile I have tested this issue and in my case, the signal of the infrared remote-control is continous. I am afraid that your remote controller or your TXT controller is broken and needs to be fixed. Please send the devices with a short error report to the following address:

fischertechnik GmbH
Klaus-Fischer-Straße 1
72178 Waldachtal
DEUTSCHLAND

Best regards,
Markus

Markus:

Thank you for your message.

I'm going first to test the program by ski7777 and see how it works.

Then I'll consider returning the items.

Dear Rei Vilo,

just to be clear: on my TXT, your program for the infrared controller works well. I am pretty sure that there is a problem with your infrared controller or your TXT.

Best regards
Markus

Markus:

Thanks! I'm sending the devices today.

Dear Rei Vilo,

I hope that you have received the new TXT controller in the meanwhile and that this error doesn't appear anymore.

Best regards,
Markus