fischertechnik community forum

Geachte, Heeft iemand ervaring met de computer Raspberry Pi? Wat zou de Raspberry Pi voor Fischer(techneut)technik kunnen betekenen? Sjors

Hello Sjors,

no, we have no experience or further informations about this modul.

ft

By itself, not much. You could connect it to an interface (robo or TX) but you'll have to write the libraries yourself. You could build motor drivers and directly control a model, which would save you an interface. The most useful thing I can think of is to run a webservice on the pi and then control e.g. a robot over the internet. You will have a lot of programming to do

@Ad2
Thanks for these informations.

ft