fischertechnik community forum

Cool, Danke für die schnelle Antwort. Also unsere haben auch eine Nase, und wie beschrieben wohl zwischen 61 und 62 Pulse pro Umdrehung. Auf jeden Fall weiß ich nun, dass es keine ganzzahligen Pulse pro Umdrehung sein müssen. Gruß Paul https://m.youtube.com/watch?v=r_yudzyAL4A&pp=ygUWZmlzY2hlcnRlY2h...

Hallo Zusammen Ich wollte mit meinem Sohn nun auch mal den Encoder Motor anschmeißen. Es handelt sich um einen Roten, der diesem ähnelt: https://www.fischerfriendsman.de/normalos/6027n.jpg Angeschlossen ist er an einem TXT Controller. Das Problem: Wir finden keine Pulszahl ("Distanz") raus die genau...

thanx
I found the thread with the "USB to serial". I guess i will just buy a new card and let then the txt start from it.
Now i took a 8 GB card, since i did not found another one, which is much too big-

regards
Jones

cool, works fine, quite straight foreward and fast. just for all, who also cannot update the txt via ROBOPro due to failure message, I started with 4.2.4 on the txt 1.) log in via ssh (USB: 192.168.7.2) and enable the bootloader via "sudo /usr/sbin/boot_sd_nand" 2.) istall v4.4.4 (ft-TXT_Build_374.i...

Thanks.
And to go from 4.2.xx to 4.4.xx I need to make the bootloader aktive via SSH? I'll try in the evening...


Regards
Jones

Dear all there was also a txt controller under the x-max tree for my son today :-) And also i have now to upskill myself... I just connected the txt controller ro the RoboPro 4.7.0. but there was the message, that the frirmware is too old (4.2.4.0). And the message 4.7.0.0 expected. Sor far so good....