Via a Win10 PC, the TXT-Controller and an old CPLD board I made a new version to control my microscope. I use a very old version MAXII CPLD board. The TXT is connected via the I2C. The housing is a 3D print version. The software for the CPLD is a smaller version of my larger Fischertechnik BOX. The CPLD has only 2000 LE compared to the 22,000 of the FPGA. Still, this was more than enough, I only need 850 LE to support all the microscope functions. Everything now runs under Win10 on a new powerful hardware.
Some pictures:
Flickr link: https://www.flickr.com/photos/fotoopa_hs/49672944763
Flickr link: https://www.flickr.com/photos/fotoopa_hs/49672944718
The microscope is equipped with a stepper motor and 5 COB power LEDs each 125W. Exposure, number of photos to be taken, step size, camera control etc. is done via the Robopro gprogram that I made earlier. 2 large UHD 32 inch screens give a good overview of the necessary programs.
Frans.
TXT-Controller and CPLD module for the microscope.
Moderator: Jan3D
Forumsregeln
Bitte beachte die Forumsregeln!
Bitte beachte die Forumsregeln!
Re: TXT-Controller and CPLD module for the microscope.
A small update:
The control interface for the PC is the previous version:
Flickr: https://www.flickr.com/photos/fotoopa_hs/48329195426
I've just made a microscope shot with the above equipment. I still had the focus sensor from my old D100 camera. The visible part of the chip is 5mm.
Flickr: https://www.flickr.com/photos/fotoopa_hs/49679553196
Thanks to the Robopro software, making the control interface is quite easy.
Frans.
The control interface for the PC is the previous version:
Flickr: https://www.flickr.com/photos/fotoopa_hs/48329195426
I've just made a microscope shot with the above equipment. I still had the focus sensor from my old D100 camera. The visible part of the chip is 5mm.
Flickr: https://www.flickr.com/photos/fotoopa_hs/49679553196
Thanks to the Robopro software, making the control interface is quite easy.
Frans.
Re: TXT-Controller and CPLD module for the microscope.
Looks very nice.